Please read the readme notes before using and installing the download. To download the file, click on the download link / filename in the last column.
Download for ESP1010
|unified driver and control panel||Windows Vista 32-bit
Windows Vista 64-bit
ESP1010 under Windows Vista
This driver is only intended for Windows Vista 32-bit and Windows Vista 64-bit, other versions of Windows are not supported. If you have installed a previous ESP1010 driver already, you need to remove it first - this is described below in the uninstallation section. Then you can proceed with driver installation.
Make sure that you have downloaded and unzipped the driver file. Install the ESP1010 hardware in your computer or if you have previously uninstalled an older driver, reboot your system. When booting the system, Windows will detect the hardware as a new device and a Found New Hardware dialog will appear automatically.
Note: if the hardware is already installed in your PC but you did not install a driver, please find the entry for an unkwon Multimedia Audio Controller in Control Panel > System > Device Manager. Right click on that and select the driver update option.
Make sure to click on Locate and install driver software (recommended). The following dialog will appear after some time:
Click on I don't have the disc. Show me other options. to continue. Please note that it might take some time until the next dialog appears:
Proceed by clicking on Browse my computer for driver software (advanced). The following dialog will be shown:
Click on Browse... and then select the folder that contains the unzipped driver. Click OK and then Next. The driver installation will now start. After some time, you will be prompted to confirm a Windows Security message. Make sure to click Install to continue.
The driver installation will now be completed until the following dialog appears:
Congratulations - you can now use ESP1010 in your system. The control panel will appear after a few seconds in the task notification area of the taskbar.
To uninstall the driver, you can use an utility that is included with the driver. Make sure you have unzipped the driver file. Open Windows Explorer and find the correct driver folder. If you are using Windows Vista 32-bit, go to the win32 folder and launch UnInstall_32 by double clicking on it. If you are using Windows Vista 64-bit, go to the x64 folder and launch Uninstall_64 by double clicking on it. When launching the uninstaller, Windows Vista might prompt a security message. Make sure to allow the uninstallation.The following dialog will appear:
Click on Uninstall. After a few seconds, this dialog confirms the procedure:
Note that in some cases, Windows will ask you if the uninstaller worked, confirm this with This program installed correctly. To re-install the updated driver (as described above), you need to reboot the system.