Please read the readme notes before using and installing the download. To download the file, click on the download link / filename in the last column.
Download for KeyControl 49
|driver||Windows Vista 32-bit
KeyControl 49 v1.02 (Windows Vista 32-bit)
This driver requires a 32-bit version of Windows Vista. It cannot be used with other versions of Windows.
First download and unzip the driver file. Make sure that KeyControl 49 is not connected to your computer before you install the driver. Then launch setup.exe from the unzipped folder. When launching the installation, Windows Vista might prompt a security message. Make sure to allow the installation. You will then see a dialog as shown on the following picture.
Click Next. You can define the target directory for the installation in the following dialog.
Confirm it with Next. The installer now informs you that the driver installation will start as shown below.
Confirm this with Next. During the following process you will see a Windows Security dialog box that asks you for confirmation to install the driver software that looks like this:
Confirm any such dialog with Install. You will then be prompted to connect the hardware in the dialog shown below.
Plug in KeyControl 49 and make sure it is switched on but do not click Next yet. Instead, wait a few seconds for the automatic device driver installation. You can monitor this in the task notification area where Windows Vista informs that the driver is installed via a bubble message box. Please note that in some cases it is possible that Windows Vista will show an error message that says the installation could not be completed. If that happens, just ignore the message. This is not important as the actual driver installation is finalized by the installer later.
Once Windows shows no further messages, you can finish the installation by clicking Next in the KeyControl49 Driver Setup dialog shown above. The installation will be fininalized now and you can start using KeyControl 49 in your applications after that.