Please read the readme notes before using and installing the download. To download the file, click on the download link / filename in the last column.
Download for KeyControl 49
|driver||Windows Vista 32-bit
Windows Vista 64-bit
Windows 7 32-bit
Windows 7 64-bit
KeyControl 49 v2.0
This driver is intended for Windows Vista 32-bit and 64-bit as well as Windows 7 32-bit and 64-bit. It cannot be used for other Windows versions.
First download and unzip the driver file. Make sure that KeyControl 49 is not connected to your computer before you install the driver. Then launch setup.exe from the unzipped folder. When launching the installation, Windows might prompt a security message. Make sure to allow the installation. You will then see a dialog as shown on the following picture.
Click Next. You can define the target directory for the installation in the following dialog.
Confirm it with Next. The installer now informs you that the driver installation will start as shown below.
Confirm this with Next. During the following process you will see a Windows Security dialog box that asks you for confirmation to install the driver software that looks like this:
Confirm any such dialog with Install. You will then be prompted to connect the hardware in the dialog shown below.
Plug in KeyControl 49 but do not click OK yet. Instead, wait a few seconds for the automatic device driver installation. You can monitor this in the task notification area where Windows informs you that the driver is installed via a bubble message box. Once Windows shows no further messages, you can finish the installation by clicking OK in the dialog shown above. After that you can start using KeyControl 49 in your applications.