Confirmation of Privacy Policy


Please note that some functions of this website require you to agree to the terms and conditions that are outlined in our privacy policy. Until then, this message will be displayed from time to time. With your consent, you also agree to the use of cookies. Additionally, by using this website, you accept that non-personalized log and tracking information from accessing our website can be saved and processed according to our privacy policy.

PRIVACY POLICY HIDE MESSAGE I AGREE

Download


Please read the readme notes before using and installing the download. To download the file, click on the download link / filename in the last column.

Download for MIDI Mate


Description Operating System Version Size Date Readme Download
driver Windows Vista 32-bit
1.002 1.391 KB 2007-12-14 readme.pdf MIDI_Mate-Vista32-v1_002.zip

MIDI Mate (Revision A, until 2006)

Please note that this driver can only be used with Revision A of MIDI Mate (sold until end of 2006) with the clear plastic case in the middle of the cable. Use this driver if your MIDI Mate looks like this:

Do not use it if it looks like this - the driver will not install:

Check this article for more details about the different products. Please also note that this driver requires a 32-bit version of Windows Vista. It cannot be used with other versions of Windows.

Installation

First download and unzip the driver file. Make sure that MIDI Mate is not connected to your computer before you install the driver. Then launch setup.exe from the unzipped folder. When launching the installation, Windows Vista might prompt a security message. Make sure to allow the installation. You will then see a dialog as shown on the following picture.

Click Next. You can define the target directory for the installation in the following dialog.

Confirm it with Next. The installer now informs you that the driver installation will start as shown below.

Confirm this with Next. During the following process you will see a Windows Security dialog box that asks you for confirmation to install the driver software that looks like this:

Confirm any such dialog with Install. You will then be prompted to connect the hardware in the dialog shown below.

Plug in MIDI Mate but do not click Next yet. Instead, wait a few seconds for the automatic device driver installation. You can monitor this in the task notification area where Windows Vista informs that the driver is installed via a bubble message box. Please note that in some cases it is possible that Windows Vista will show an error message that says the installation could not be completed. If that happens, just ignore the message. This is not important as the actual driver installation is finalized by the installer later.

Once Windows shows no further messages, you can finish the installation by clicking Next in the MIDI Mate Driver Setup dialog shown above. The installation will be fininalized now and you will see that the LED inside MIDI Mate gets switched on. The installation is now finished and you can start using MIDI Mate in your applications.